Definition of tube ignition. Meaning of tube ignition. Synonyms of tube ignition

Here you will find one or more explanations in English for the word tube ignition. Also in the bottom left of the page several parts of wikipedia pages related to the word tube ignition and, of course, tube ignition synonyms and on the right images related to the word tube ignition.

Definition of tube ignition

tube ignition
Internal-combustion engine Internal-combustion engine) in which the heat or pressure energy necessary to produce motion is developed in the engine cylinder, as by the explosion of a gas, and not in a separate chamber, as in a steam-engine boiler. The gas used may be a fixed gas, or one derived from alcohol, ether, gasoline (petrol), naphtha, oil (petroleum), etc. There are three main classes: (1) gas engines proper, using fixed gases, as coal, blast-furnace, or producer gas; (2) engines using the vapor of a volatile fluid, as the typical gasoline (petrol) engine; (3) oil engines, using either an atomized spray or the vapor (produced by heat) of a comparatively heavy oil, as petroleum or kerosene. In all of these the gas is mixed with a definite amount of air, the charge is composed in the cylinder and is then exploded either by a flame of gas ( flame ignition -- now little used), by a hot tube ( tube ignition) or the like, by an electric spark ( electric ignition, the usual method is gasoline engines, or by the heat of compression, as in the Diesel engine. Gas and oil engines are chiefly of the stationary type. Gasoline engines are largely used for automobile vehicles, boats, etc. Most internal-combustion engines use the Otto (four-stroke) cycle, though many use the two-stroke cycle. They are almost universally trunk engines and single-acting. Because of the intense heat produced by the frequent explosions, the cylinders must be cooled by a water jacket ( water-cooled) or by air currents ( air cooled) to give the maximum thermodynamic efficiency and to avoid excessive friction or seizing. Interne In*terne", n. [F.] (F. pron. [a^]N`t[^a]rn") (Med.) A resident physician in a hospital; a house physician.

Meaning of tube ignition from wikipedia

- liquid. This phenomenon is called bumping. An ignition tube is used in much the same way as a boiling tube, except it is not as large and thick-walled....
- area of the tube, ignition occurs. On early designs, ignition timing was adjusted by adjusting the position of the red-hot spot on the tube - the burner...
- German engineer Rudolf Diesel, is an internal combustion engine in which ignition of the fuel is caused by the elevated temperature of the air in the cylinder...
- inventors of the time. Daimler relied on hot tube ignition, until 1897, when he adopted the electrical ignition designed by Bosch. The engine with the flywheel...
- require ignition of the mixture, either by spark ignition (SI) or compression ignition (CI). Before the invention of reliable electrical methods, hot tube and...
- low ignition voltage and is frequently used in low-voltage tubes. Discharge in neon emits relatively bright red light; neon-filled switching tubes therefore...
- intake stroke, and instead of an electrical ignition system, it used hot tube ignition, a platinum tube running into the combustion chamber, heated by...
- between laboratory equipment. Example laboratory sample tubes are listed below: Ignition tube Test tube Boiling tube NMR tube Laboratory gl****ware v t e...
- Capacitor discharge ignition (CDI) or thyristor ignition is a type of automotive electronic ignition system which is widely used in outboard motors, motorcycles...
- carburetor which replaced the original hot tube ignition on the Daimler Reitwagen, and a magneto ignition system which formed the basis of the magneto...