-
libATA is a
library used
inside the
Linux kernel to
support ATA host
controllers and devices.
libATA provides an
ATA driver API,
class transports for ATA...
-
support hot
swapping of hard disks.
Electronics portal FATA (hard disk drive)
libATA List of
interface bit
rates "AT" is
derived from the IBM
Personal Computer/AT...
-
devices are
blacklisted in the
Linux kernel's
libata-core.c to
force sending non-queued TRIM
commands (
ATA_HORKAGE_NO_NCQ_TRIM) to
these drives instead...
- ipv6 290404 22 xfs 568384 4 sis900 18052 5
libata 169920 1
pata_sis scsi_mod 158316 3 usb_storage,sd_mod,
libata usbcore 155312 6 ohci_hcd, usb_storage, usbhid...
- of low-level
common services used by
device drivers: SCSI
Interfaces and
libATA – respectively, a peer-to-peer
packet based communication protocol for storage...
- mmcblk0p1:
first registered device's
first partition SCSI driver, also used by
libATA (modern PATA/SATA driver), USB, IEEE 1394, etc.: sd: m****-storage driver...
- 2014-01-21. "
libata:
Support for an
ATA P****-THROUGH(32) command".
Linux kernel Patchwork. Jun 24, 2017. "T10
Working Drafts: SCSI /
ATA Translation"...
-
implemented so
badly in the WD740ADFD-00NLR1 that it has been
added to the
Linux libata drive blacklist. The WD740GD did not
apply because it uses TCQ and not NCQ...
- (Was Re: [RFC][PATCH]
libata:
Enable SATA disk fua
detection on default) (Linux SCSI)". "Linux-Kernel Archive: [PATCH RFC]
libata: FUA updates". "Shaver »...
- kernel.org.
Retrieved 2013-12-12.
Tejun Heo. "LKML:
Tejun Heo: [GIT PULL]
libata changes for v3.12-rc1". lkml.org.
Archived from the
original on 2016-01-17...
